Hello everyone...
I think my ECU is fried...Not 12V to the coil when I push button start
although Relay Unit and Solenoid Relay are ok...And the black/green wire fron te button to ECU is alimentated with 12V also if not pressed....
And the other wire the Blue/white one also....
Is it correct?

Did you checked the lean angle sensor and the kill switch?


Cheers
Krieger

Oh yeah....kill switch Is on ....and the wires Black Red have 12v....by diagnostic lean cit off Is in the range...This Is a very misterious.....Someone can check the two wire of button start and telo me which One has 12v continuity? Some Warrior's Owner has only 1 cable Blue/White to the start switch........Is a very misterious

The Starter works and you only have no power at the coils?

I've to replace ECU.....It fried......
I've fried 2 not only 1....